I recently took a trip to Japan, which resulted slight increase of the back log of model. Therefore, it is time to finish some work in progress. This GM is inspired from the GM sniper II from Studio Reckless. I started the construction during July 2004 to October 2004. However, I let the kit stewed until last week to start painting it.


I started out from GM-command cold district kit. Originally I converted the RGM-79D head to a GM-C head. However, I opted for the sniper style head.

The shoulder armor is scratch built.

The sniper head can be conveniently converted from the GM command head. One can cut off the fore head camera to use as the visor camera. The two side knobs are Kotobukiya minus molds connected to the visor camera by two strips of 0.20mm styrene. After leaving the visor structure over night for the cement to dry, the detailings are done by 0.35mm styrene and Tamiya grey putty.


After cutting off the forhead camera, the hole on the head is refilled with epoxy putty. I did not like the vents on the sides of the face so I replace them with the ones I built from 0.35mm styrene. The top of the mouth piece are trimmed down by file.


The feet and ankle are also scrtchbuilt.

You can use the Evergreen styrene tubes to construct the ankle. An even number tube can fit into the next larger even number tube, I jammed a small glob of Sticktag between the tubes to increase the friction.

Dark gray is used as the base coat for all colors. Dark green shaded with gray are used on most parts and lighy greay are used on the shoulder, feet, neck base, and the face vents. The shading for the dark green by dark gray is not is noticable if I used dark blue as the base coat. Next time I should test out the shading on a piece of styrene instead of working it out in my head.